cgminer 2.2.0 segfaulting

LulzMoney · 2012-01-31 22:30:34

I recently upgraded to cgminer 2.2.0 running the latest catalyst 12.1 drivers. for some reason i keep getting a segmentation fault every time I try to run this. I am also on the 3.2.2-1-ARCH kernel. Any idea what I am doing wrong?

Arhat · 2012-02-05 10:58:32

Yes, I can confirm that. 3.2.2-1-ARCH kernel and catalyst 12.1-1 segfaults.

/Edit:

strace output here:
cgminer

Last edited by Arhat (2012-02-05 14:41:21)

LulzMoney · 2012-02-05 21:05:22

thanks. I rolled back to the 11.12 drivers and everything works fine. I put them in the IgnorePackages line in pacman.conf until this is resolved. I cannot wait until the open drivers support OpenCL.

Arhat · 2012-02-06 07:02:01

It seems a lot of the paths are messed up.

I'm going to try to sort that out if I find time this week.

Have you seen this though?
A linux distro dedicated to bitcoin

I'm going to try that and if it works use that for mining. Then I don't have to roll back to any old drivers.

LulzMoney · 2012-02-06 09:38:56

I have seen that and am definitely considering doing that for my next miner, whenever I can get that going that is

Arch Linux

#1 2012-01-31 22:30:34

cgminer 2.2.0 segfaulting

#2 2012-02-05 10:58:32

Re: cgminer 2.2.0 segfaulting

#3 2012-02-05 21:05:22

Re: cgminer 2.2.0 segfaulting

#4 2012-02-06 07:02:01

Re: cgminer 2.2.0 segfaulting

#5 2012-02-06 09:38:56

Re: cgminer 2.2.0 segfaulting

Board footer