You are not logged in.
So I'm trying to switch to kde not because I dislike gnome but because I'm curious about kde. So far I've had a few issues that keep me going back to gnome where I haven't even had to deal with this problems.
I have a Thinkpad X201 which is a small laptop (12.1 inch screen). When I get to work I dock and close the lid and use a 21 inch screen. The laptop screen is off. When I un-dock it, it seamlessly switches back to the laptop screen. I didn't have to do anything to get this to work in gnome other than set it up under the display settings. KDE, I have to configure it on each boot, and it seems a little buggy sometimes (as in it doesn't do the same thing each time even though I go through the same proceedure, like the laptop monitor says even when I say to disable it, until I re-enable it and disable it a second time). It doesn't always happen but it does sometimes. I know I can default it to one setting but when I un-dock it or reboot it with the external monitor as default it doesn't go back to the laptop display like gnome does (which mean I don't get a screen on my laptop to switch it back to the laptop). I went through the intel/xorg/kde wiki's and either I missed it or it doesn't really say anything about my situation. I saw the multi-monitor settings for xorg and tried it but it did nothing.
This alone make kde not an option as I'm constantly going back and forth from docked to un-docked and can't keep manually switching display settings.
Also, I tried my vm's in virtualbox and it complained as I started the vm that it was configured for 32 color but that kde is set to 24 bit. I see no settings to change it in kde and forcing it with an xorg config file does not take. How do I change it to 32bit color?
Some of the other quirks I can sort of deal with (clock size, qt/gtk integration, others) but those above will keep me gnome until they can be solved.
$ lspci
00:00.0 Host bridge: Intel Corporation Core Processor DRAM Controller (rev 02)
00:02.0 VGA compatible controller: Intel Corporation Core Processor Integrated Graphics Controller (rev 02)
00:16.0 Communication controller: Intel Corporation 5 Series/3400 Series Chipset HECI Controller (rev 06)
00:19.0 Ethernet controller: Intel Corporation 82577LM Gigabit Network Connection (rev 06)
00:1a.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset High Definition Audio (rev 06)
00:1c.0 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 1 (rev 06)
00:1c.3 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 4 (rev 06)
00:1c.4 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 5 (rev 06)
00:1d.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev a6)
00:1f.0 ISA bridge: Intel Corporation Mobile 5 Series Chipset LPC Interface Controller (rev 06)
00:1f.2 SATA controller: Intel Corporation 5 Series/3400 Series Chipset 6 port SATA AHCI Controller (rev 06)
00:1f.3 SMBus: Intel Corporation 5 Series/3400 Series Chipset SMBus Controller (rev 06)
00:1f.6 Signal processing controller: Intel Corporation 5 Series/3400 Series Chipset Thermal Subsystem (rev 06)
02:00.0 Network controller: Intel Corporation Centrino Advanced-N 6200 (rev 35)
ff:00.0 Host bridge: Intel Corporation Core Processor QuickPath Architecture Generic Non-core Registers (rev 02)
ff:00.1 Host bridge: Intel Corporation Core Processor QuickPath Architecture System Address Decoder (rev 02)
ff:02.0 Host bridge: Intel Corporation Core Processor QPI Link 0 (rev 02)
ff:02.1 Host bridge: Intel Corporation Core Processor QPI Physical 0 (rev 02)
ff:02.2 Host bridge: Intel Corporation Core Processor Reserved (rev 02)
ff:02.3 Host bridge: Intel Corporation Core Processor Reserved (rev 02)Offline
bump... I'm not like too much where gnome 3.4 is going so I really was hoping to get kde to work.
Offline
Are you running krandtray? If not, maybe running it would change something. Or at least make it easier to handle your screens.
Offline
The most desktop agnostic way of doing this would be creating a udev rule that calls xrandr commands. Do any of the tricks here work for you? http://www.thinkwiki.org/wiki/Docking_Solutions
6EA3 F3F3 B908 2632 A9CB E931 D53A 0445 B47A 0DAB
Great things come in tar.xz packages.
Offline
The problem I'm having is more extreme than yours but possibly related. (There's a thread here somewhere and a forum thread on the KDE site.) I need to sit down and try to recreate the issue in my office.
Apart from the configure-every-time on connect and configure-twice on disconnect, I also tend to find I lose all display on disconnect (not immediately but shortly after). Either ll display for X or all display period.
It is probably the biggest issue I have right now (apart from the new kernels - but the lts one works great).
Possibly related:
https://bugs.kde.org/show_bug.cgi?id=291819
https://bbs.archlinux.org/viewtopic.php … 0#p1079700
http://forum.kde.org/viewtopic.php?f=22&t=101058
There are some other bugs/threads on the KDE sites if you search...
CLI Paste | How To Ask Questions
Arch Linux | x86_64 | GPT | EFI boot | refind | stub loader | systemd | LVM2 on LUKS
Lenovo x270 | Intel(R) Core(TM) i5-7200U CPU @ 2.50GHz | Intel Wireless 8265/8275 | US keyboard w/ Euro | 512G NVMe INTEL SSDPEKKF512G7L
Offline