You are not logged in.

#1 2012-04-05 22:49:48

_saiko
Member
From: systemreich
Registered: 2007-08-06
Posts: 91
Website

Zoneminder 1.25.0

Did anyone manage to successfully configure and use this app?

I managed to compile and set most things but there are some real issues going on:

During capture the event cannot be viewed (it's displayed with 0 frames) and the CPU goes 100%. Only after the mode is switched (or zm restarted) the event is updated and is viewable. Basically if motion detection is on and an event/motion is detected, you have to stop capture in order to actually view the event.

Also the control buttons and progress bar in event viewer are not working. The captured video is playing but there is no way to pause/skip/ff/rw..


cat.7 - where crosstalk is not an issue anymore :'(

Offline

#2 2012-08-07 10:41:51

Jindur
Member
Registered: 2011-09-29
Posts: 184

Re: Zoneminder 1.25.0

How did you compile it? I had this https://bbs.archlinux.org/viewtopic.php … 1#p1142951 error. sad

Offline

Board footer

Powered by FluxBB