You are not logged in.

#1 2012-04-21 12:56:38

sigma91
Member
Registered: 2010-07-31
Posts: 18

[SOLVED] Install printer using a deb package

Hi,

There's no ppd for my printer (Brother DCP-7055) and the manufacturer only supplies a debian package, so I installed it according to this german wiki. The wiki basically says to extract the deb package, change a few lines in the extracted files, copy these files to /usr and run a script that has been copied to /usr/local/Brother/Printer/DCP7055/cupswrapper/. I did this, and I got it working after changing the connection to parallel:/dev/lp0 with usblp loaded (NOT blacklisted). However, I recently installed archlinux on a new ssd, installed cups and tried installing the printer, but it doesn't work now. I can still boot the old harddrive where it works fine.

The printer is recognized in cups and it accepts jobs, but the jobs are, according to cups, completed at the second they are sent, even though the printer doesn't print anything.

Here's the output of lsmod from the old system: http://nopaste.info/9e4add1629.html
Here's the /var/log/cups/error_log after restarting cups and printing a test page using the web interface: http://nopaste.info/dbdce9e66f.html

I have no idea what I did different on my old system, but luckily, I can still access the whole filesystem or boot it. I already copied the cupsd.conf to the new system, without any success. If you have a clue, you can just tell me which config-files or directories I should compare. Thanks in advance.


EDIT:
It works now, I installed lib32-glibc and lib32-libstdc++5, then I had to change a few file permissions in /usr/local/Brother. I'm not sure what exactly fixed the problem though.

Last edited by sigma91 (2012-06-17 20:57:15)

Offline

Board footer

Powered by FluxBB