You are not logged in.
The latest update fixed the issue.
------------------------
Here's a section from everything.log:
May 4 19:31:06 localhost kernel: [ 4.721287] pcmcia_socket pcmcia_socket0: cs: memory probe 0xa0000000-0xa0ffffff: clean.
May 4 19:31:06 localhost kernel: [ 4.736081] pcmcia_socket pcmcia_socket0: cs: memory probe 0x60000000-0x60ffffff: clean.
May 4 19:31:06 localhost kernel: [ 4.747588] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
May 4 19:31:06 localhost kernel: [ 4.847466] e1000 0000:02:01.0: eth0: (PCI:33MHz:32-bit) 00:11:25:b3:f3:ff
May 4 19:31:06 localhost kernel: [ 4.851236] e1000 0000:02:01.0: eth0: Intel(R) PRO/1000 Network Connection
May 4 19:31:06 localhost kernel: [ 4.855109] ipw2100 0000:02:02.0: PCI INT A -> Link[LNKC] -> GSI 11 (level, low) -> IRQ 11
May 4 19:31:06 localhost kernel: [ 4.867475] ipw2100: Detected Intel PRO/Wireless 2100 Network Connection
May 4 19:31:06 localhost kernel: [ 5.076702] intel8x0_measure_ac97_clock: measured 52634 usecs (2536 samples)
May 4 19:31:06 localhost kernel: [ 5.080237] intel8x0: clocking to 48000
May 4 19:31:06 localhost kernel: [ 6.937661] psmouse serio2: hgpk: ID: 10 00 64
May 4 19:31:06 localhost kernel: [ 10.443992] IBM TrackPoint firmware: 0x0e, buttons: 3/3Then after about 20 seconds or so it continues to this:
May 4 19:31:06 localhost kernel: [ 35.420710] cfg80211: failed to add phy80211 symlink to netdev!
May 4 19:31:06 localhost kernel: [ 35.960505] EXT4-fs (sda3): re-mounted. Opts: (null)
May 4 19:31:06 localhost kernel: [ 36.132575] EXT4-fs (sda4): mounted filesystem with ordered data mode. Opts: (null)
May 4 19:31:06 localhost kernel: [ 36.207779] EXT4-fs (sda1): mounting ext2 file system using the ext4 subsystem
May 4 19:31:06 localhost kernel: [ 36.212490] EXT4-fs (sda1): mounted filesystem without journal. Opts: (null)
May 4 19:31:06 localhost kernel: [ 36.333126] Adding 265068k swap on /dev/sda2. Priority:-1 extents:1 across:265068k
May 4 19:31:06 localhost kernel: [ 37.765096] ADDRCONF(NETDEV_UP): eth0: link is not readyAny ideas?
Thanks!
Last edited by uberscientist (2012-08-21 17:12:13)
Offline