You are not logged in.

#1 2012-05-09 21:32:38

miggy
Member
From: MT
Registered: 2007-11-05
Posts: 67

gnome run command source .bashrc

Hi, after using just xmonad for a long time I'm now trying to get gnome and xmonad to play nicely together.  I am starting my gnome-xmonad session from GDM which was started with runlevel 5 in inittab--I followed the wiki.  Now in gnome, the run command dialogue (alt-f2) does not seem to source my ~/.bashrc.  I use an xmonad run util and under gnome-xmonad that run util does not source my ~/.bashrc either.  I have my PATH specified in my .bashrc but I cannot run the commands that rely on the path set in .bashrc.  I do have a ~/.bash_profile which sources ~/.bashrc, so that is not the issue.  In a terminal, my path is fine, but not from those run dialogues.  The xmonad run util worked fine when I would start xmonad with startx.  Any advice on how to get gnome to source my ~/.bashrc?

Offline

#2 2012-05-10 08:49:40

skanky
Member
From: WAIS
Registered: 2009-10-23
Posts: 1,847

Re: gnome run command source .bashrc

I don't know about sourcing your .bashrc in gnome, but you are probably better off moving your PATH definition to your .bash_profile, before you source the .bashrc.


"...one cannot be angry when one looks at a penguin."  - John Ruskin
"Life in general is a bit shit, and so too is the internet. And that's all there is." - scepticisle

Offline

Board footer

Powered by FluxBB