You are not logged in.

#1 2012-05-12 15:11:46

Agamemnon
Member
From: France
Registered: 2011-05-05
Posts: 42

Automount in Gnome 3.4.1 is broken

Hi all!

I have a strange issue with gnome 3.4.1 and automount on both my laptop and my PC.
When I plug an usbkey, I can hear the sound "plop" but nothing happen, no notification to open nautilus, and in nautilus, the usb device isn't showed, isn't mounted.

When is do lsusb, I can't see my usb key listed:

Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 006 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 005 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 002 Device 005: ID 1e3d:8246 
Bus 005 Device 003: ID 046d:c52e Logitech, Inc.
Bus 005 Device 004: ID 0b05:179c ASUSTek Computer, Inc.

but dmesg shows this:

[  754.994691] usb 2-1.2: new high-speed USB device number 5 using ehci_hcd
[  755.078996] scsi10 : usb-storage 2-1.2:1.0
[  756.079519] scsi 10:0:0:0: Direct-Access     YHS      V88              5.00 PQ: 0 ANSI: 2
[  756.080385] sd 10:0:0:0: [sdb] 8108032 512-byte logical blocks: (4.15 GB/3.86 GiB)
[  756.080852] sd 10:0:0:0: [sdb] Write Protect is off
[  756.080855] sd 10:0:0:0: [sdb] Mode Sense: 0b 00 00 08
[  756.081348] sd 10:0:0:0: [sdb] No Caching mode page present
[  756.081350] sd 10:0:0:0: [sdb] Assuming drive cache: write through
[  756.083618] sd 10:0:0:0: [sdb] No Caching mode page present
[  756.083621] sd 10:0:0:0: [sdb] Assuming drive cache: write through
[  756.084346]  sdb: sdb1
[  756.086987] sd 10:0:0:0: [sdb] No Caching mode page present
[  756.086990] sd 10:0:0:0: [sdb] Assuming drive cache: write through
[  756.086991] sd 10:0:0:0: [sdb] Attached SCSI removable disk

I use systemd and udisks2.service is running well.
Do you have an idea of how I can correct this?


Pc: Intel core i7, 8Gb RAM, Archlinux 64bits, Gnome 3
Laptop 1: Intel Core2Duo, 4Gb RAM, Archlinux 64bits, Gnome 3
Laptop 2: Intel P4 HT, 512Mb RAM, Archlinux 32 bits, Gnome 3 too

Offline

Board footer

Powered by FluxBB