You are not logged in.

#1 2012-06-08 20:11:27

dicaiopolis
Member
Registered: 2010-07-21
Posts: 126

Iso automount not working after upgrade

Hi,

I've upgraded my system and my isos aren't being mounted at boot time anymore. This used to work pretty fine before I upgrade, but now I get the following error message during the boot: "Mounting local filesystems fail". I commented my fstab lines pointing to isos and the error message was gone. Here is my fstab (the isos' path are correct):

tmpfs		/tmp	tmpfs	nodev,nosuid	0	0
/dev/sda5 /boot ext4 defaults,noatime 0 1
/dev/sda6 / ext4 defaults,noatime 0 1
/dev/sda7 /home ext4 defaults,noatime 0 1
/dev/sda8 swap swap defaults 0 0
dev/sda2		/media/C 	ntfs-3g    	defaults,locale=en_US.UTF-8	0 	0
/dev/sda3		/media/D 	ntfs-3g    	defaults,locale=en_US.UTF-8	0 	0
/home/andre/Iso/Tlg.iso /media/Tlg 	udf,iso9660  	user,loop  			0 	0
/home/andre/Iso/Phi5.iso /media/Phi 	udf,iso9660  	user,loop  			0 	0
/home/andre/Iso/Il_Verbo_Greco.iso /media/VerboGreco 	udf,iso9660  	user,loop  			0 	0

Any idea about what's going on and a possible solution?

Thanks a lot.

Offline

#2 2012-06-08 20:26:13

dicaiopolis
Member
Registered: 2010-07-21
Posts: 126

Re: Iso automount not working after upgrade

Another detail: when I do "mount -a" I get:

mount: unknown filesystem type 'udf,iso9660'

Any idea?

Offline

#3 2012-07-19 12:04:44

allencch
Member
Registered: 2011-03-25
Posts: 120

Re: Iso automount not working after upgrade

Same problem.

Offline

Board footer

Powered by FluxBB