You are not logged in.

#1 2012-08-02 21:18:02

onexused
Member
Registered: 2009-10-07
Posts: 117

Running X on two video cards

I'm trying to run an X session and stretch my display across three monitors on two cards.  Without an xorg.conf, X has no problems starting up and using the two monitors on the first card, however it doesn't seem to know anything about the second card.  With the /etc/X11/xorg.conf.d/10-screens.conf pasted below, X refuses to start, "no screens found".  What's the issue?

lspci: https://gist.github.com/3240582
/etc/X11/xorg.conf.d/10-screens.conf: https://gist.github.com/3240302
Xorg.0.log with above config: https://gist.github.com/3240591
Xorg.0.log with no xorg.conf: https://gist.github.com/3240693
Xorg.0.log with the driver set to "radeon" in the above xorg.conf: https://gist.github.com/3240681

Offline

#2 2012-08-06 19:41:46

onexused
Member
Registered: 2009-10-07
Posts: 117

Re: Running X on two video cards

Well, in case anyone else has this problem, the issues were as follows:
- The correct driver for the PCI card is "radeon", not "ati".
- While lspci uses hexidecimal, X expects decimal in its configs (so my card was at 0:10.0 according to lspci and 0:16.0 according to X).
- While lspci uses a period in its PCI Bus location ( 0:10.0 ), X expects only colons ( 0:16:0 ).
- There was no kernel module loaded for the integrated AGP card.  I haven't investigated which one it uses yet.
Thanks to Triskelios on #xorg@irc.freenode.net (finally).

Offline

#3 2012-08-07 04:06:08

ConnorBehan
Package Maintainer (PM)
From: Long Island NY
Registered: 2007-07-05
Posts: 1,359
Website

Re: Running X on two video cards

The kernel module for the Rage Pro is mach64. I think it is not included with the Linux kernel right now because of a vulnerability.


6EA3 F3F3 B908 2632 A9CB E931 D53A 0445 B47A 0DAB
Great things come in tar.xz packages.

Offline

Board footer

Powered by FluxBB