You are not logged in.

#1 2012-08-13 16:54:24

el_zoona
Member
From: Argentina
Registered: 2008-02-01
Posts: 58
Website

[SOLVED] No network (carrier lost) during install

Hi, I'm trying to install the latest ISO (i686) in a HP 6910p, with in an Intel 82566MM eth and according to /var/log/daemons.log the carriers is lost, according to my router, the IP is assigned but the connection only last between 4 and 10 seconds.

pinging anything results in Network is unreachable.

Daemons.log says: eth0: carrier lost; MTU restored to 1500; Carrier acquired; sending ipv6 router solicitation; sendmsg: cannot assing requested address; Then the ip is leased, and immediately after that the MTU is set to 576 and the carrier lost again.

I've tried using dhcpd eth0 --nohook mtu. Also tried dhclient, but it only worked one time and can't remember why! Removed /var/run/dhcpd*. restarted network daemon, everything. The eth interface works fine from Ubuntu 12.04 livecd.

Any help would be appreciated, thanks a lot!

EDIT: Not really solved, but fixed for now. See #3 post for solution.

Last edited by el_zoona (2012-08-13 17:17:47)


// Send more Chuck Berry

Offline

#2 2012-08-13 16:57:45

WonderWoofy
Member
From: Los Gatos, CA
Registered: 2012-05-19
Posts: 8,414

Re: [SOLVED] No network (carrier lost) during install

What kind of network card are you using?  list the output of lspci.  I had really really spotty connectivity with my ethernet when trying to install, until I realized that I had a Realtek 8168B, while the standard install/installer only has the r8169 module.  So once I downloaded and began using the r8168 module it works great now.

Offline

#3 2012-08-13 17:16:42

el_zoona
Member
From: Argentina
Registered: 2008-02-01
Posts: 58
Website

Re: [SOLVED] No network (carrier lost) during install

An Intel 8256MM. So far it's working, i've deleted everything from dhcpd (rm /var/run/dhcpd*) and stopeed dhcpd from trying to control the card (dhcpd -x eth0) the dhclient (dhclient eth0) and it's working right now. Would install (explicitly installing dhclient since it's not in base) and see how it works from there!

Thanks!


// Send more Chuck Berry

Offline

#4 2012-08-13 17:37:04

WonderWoofy
Member
From: Los Gatos, CA
Registered: 2012-05-19
Posts: 8,414

Re: [SOLVED] No network (carrier lost) during install

No problem, even though I really didn't help you at all.  But good job helping yourself!  I use dhclient exclusively.  I still have dhcpcd installed just in case (the worst possible situation I think would be needing dhcpcd to debug, yet also needing a stable interweb connection to install that dhcpcd).  I don't remember why I started using dhclient, but I figure there must have been some kind of a reason for it... otherwise I probably would not even know there was an alternative to dhcpcd.

Offline

Board footer

Powered by FluxBB