You are not logged in.

#1 2012-10-14 13:24:55

kreoso
Member
Registered: 2012-02-27
Posts: 19

netcfg problem

I have followed the Beginner's Guide, but after reboot I don't have internet connection.

It's not the hardware or connection problem, cause when I configure the network settings manually with the procedure ip, it just works.

I think, net-auto-wired.service uses /usr/bin/ifplugd, but it isn't there.

Offline

#2 2012-10-14 23:08:20

thestinger
Trusted User (TU)
From: Toronto, Canada
Registered: 2010-01-23
Posts: 478

Re: netcfg problem

kreoso wrote:

I have followed the Beginner's Guide, but after reboot I don't have internet connection.

It's not the hardware or connection problem, cause when I configure the network settings manually with the procedure ip, it just works.

I think, net-auto-wired.service uses /usr/bin/ifplugd, but it isn't there.

You'll need to install ifplugd, which is required for net-auto-wired. I forgot to include that when I replaced the old initscripts network daemon there.

Offline

Board footer

Powered by FluxBB