You are not logged in.

#1 2012-10-26 14:42:36

Technicolor
Member
From: Earth
Registered: 2012-09-05
Posts: 32

fbsplash - does not work properly

Hi.
So I installed fbsplash, fbsplash-extras and fbsplash-themes-arch-banner from the AUR, and configured it exactly as it said in the wiki, and when I mkinitcpio, grub-mkconfig and then when I reboot, it loads the picture, saying "Loading kernel", and it just stays there, doing nothing. I do Ctrl-Alt-F1, and it brings me to the login screen.

Now, it worked just fine on another machine, but the only differences were that on that machine I had lightdm start with it, and it was pre-systemd. This laptop is post-systemd and does not have a DM.

When I did the mkinitcpio it gave me this warning:

/etc/rc.d/functions.d/fbsplash-extras.sh: line 370: /etc/rc.conf: No such file or directory
/etc/splash/arch-banner-icons/scripts/rc_init-pre: File not found: '/usr/share/icons/Tango/16x16/status/dialog-warning.png'
/etc/splash/arch-banner-icons/scripts/rc_init-pre: File not found: '/usr/share/icons/Tango/32x32/devices/computer.png'
/etc/splash/arch-banner-icons/scripts/rc_init-pre: File not found: '/usr/share/icons/Tango/32x32/devices/system.png'
/etc/splash/arch-banner-icons/scripts/rc_init-pre: File not found: '/usr/share/icons/Tango/32x32/devices/drive-harddisk.png'

..but created the image successfully, which gives me a suspicion that systemd is causing all these problems.

Any ideas?

side question: I am trying to integrate the hibernate (uswsusp-fbsplash from the AUR and pm-utils) with it, and I added the lines from the wiki onto my /etc/default/grub file, added the hook, did mkinitcpio, and did grub-mkconfig, but when I boot with grub (without hibernating or anything), it gives me the error "Cannot stat /dev/sda99" and asks me to give it the proper location (although on grub, I added "resume=/dev/sda7", which is my swap partition)

Last edited by Technicolor (2012-10-26 14:46:41)

Offline

#2 2012-10-26 14:54:33

WonderWoofy
Member
From: Los Gatos, CA
Registered: 2012-05-19
Posts: 8,414

Re: fbsplash - does not work properly

Are you using systemd?  If so I believe you need to be using plymouth, as I am not entirely sure that fbsplash is set up to be compatible with sysvinit.

Offline

#3 2012-10-26 15:03:38

Technicolor
Member
From: Earth
Registered: 2012-09-05
Posts: 32

Re: fbsplash - does not work properly

WonderWoofy wrote:

Are you using systemd?  If so I believe you need to be using plymouth, as I am not entirely sure that fbsplash is set up to be compatible with sysvinit.

Yeah, that's what I was partially fearing. I like plymouth, but I'd really use fbsplash than plymouth.

And evidently it isn't.

I guess I'll install plymouth later, since it's pretty buggy at this moment. I tried installing both plymouths, the AUR one and the AUR-git one, but both failed. Oh well. No pretty splash screen for me (yet).

Last edited by Technicolor (2012-10-26 15:09:28)

Offline

Board footer

Powered by FluxBB