You are not logged in.

#1 2012-12-12 19:33:30

kdar
Member
From: Alabama!!!
Registered: 2009-06-27
Posts: 352

GATT interfacing application in Linux? (using gatttool)

I am using CC2540 Bluetooth Low-Energy development board. And today I was trying to connect to it using hcitool and gatttool.
I used following commands to scan and connect with hcitool:

$ sudo hcitool lescan
[sudo]LE Scan ...
78:C5:E5:6C:8A:01 (unknown)
78:C5:E5:6C:8A:01 OBP425-8A01
$ sudhcitool lecc 78:C5:E5:6C:8A:01
Connection handle 64

and later, I tried to connect with gatttool to read different UUIDs that I have inside application code of CC2540:

$ sudo gatttool -i hci0 -b 78:C5:E5:6C:8A:01 -m 48 --interactive
[   ][78:C5:E5:6C:8A:01][LE]> connect
[CON][78:C5:E5:6C:8A:01][LE]> char-read-uuid ffe1
[CON][78:C5:E5:6C:8A:01][LE]> 
handle: 0x0037   value: 1d 
[CON][78:C5:E5:6C:8A:01][LE]> 

But.... Can I write a little problem or maybe just a script to read some particular (1-3) uuid(s) every second?

Last edited by kdar (2012-12-12 22:38:41)

Offline

Board footer

Powered by FluxBB