You are not logged in.
Yesterday I noticed that I couldn't use my mouse (usb) when I started Openbox (standalone). I can use the keyboard. My wifi connection (usb diongle) fails as well. Normally my wifi connection is set up automatically at boot. A minute after Openbox starts the mouse is working again. I connect manually to the internet. Today I have the same problem. But now netcfg tells me wlan0 does not exist. Neither the mouse nor the usb dongle show up in the lusb list. After a while it does.(?).
I have a second Arch system on my second HD. When I start this one, there are no problems with the mouse and the usb dongle. They are listed by lusb from the start.
journalctl -b shows there is something going on with usb:
Feb 13 13:03:54 002 netcfg[237]: :: fc949 up interface wlan0 does not exist
Feb 13 13:03:54 002 netcfg[237]: [fail]
Feb 13 13:03:55 002 kernel: usb 1-4: device descriptor read/64, error -110
Feb 13 13:04:09 002 systemd-udevd[97]: worker [127] /devices/pci0000:00/0000:00:10.3/usb1 timeout; kill it
Feb 13 13:04:09 002 systemd-udevd[97]: seq 964 '/devices/pci0000:00/0000:00:10.3/usb1' killed
Feb 13 13:04:09 002 mtp-probe[346]: checking bus 1, device 2: "/sys/devices/pci0000:00/0000:00:10.3/usb1/1-2"
Feb 13 13:04:09 002 mtp-probe[346]: bus: 1, device: 2 was not an MTP device
Feb 13 13:04:10 002 kernel: cfg80211: Calling CRDA to update world regulatory domain
Feb 13 13:04:10 002 kernel: usb 1-4: device descriptor read/64, error -110
Feb 13 13:04:10 002 kernel: usb 1-4: new high-speed USB device number 6 using ehci_hcd
Feb 13 13:04:20 002 kernel: usb 1-4: device not accepting address 6, error -110
Feb 13 13:04:22 002 kernel: usb 1-4: new high-speed USB device number 7 using ehci_hcd
Feb 13 13:04:31 002 kernel: usb 1-4: device not accepting address 7, error -110
Feb 13 13:04:31 002 kernel: hub 1-0:1.0: unable to enumerate USB device on port 4
Feb 13 13:04:31 002 systemd-udevd[97]: worker [127] terminated by signal 9 (Killed)
Feb 13 13:04:31 002 kernel: usb 1-2: reset high-speed USB device number 2 using ehci_hcd
Feb 13 13:04:40 002 systemd-udevd[97]: worker [120] /devices/pci0000:00/0000:00:10.3/usb1/1-2/1-2:1.0 timeout; kill it
Feb 13 13:04:40 002 systemd-udevd[97]: seq 967 '/devices/pci0000:00/0000:00:10.3/usb1/1-2/1-2:1.0' killed
Feb 13 13:04:46 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:05:01 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:05:02 002 kernel: usb 1-2: reset high-speed USB device number 2 using ehci_hcd
Feb 13 13:05:17 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:05:32 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:05:32 002 kernel: usb 1-2: reset high-speed USB device number 2 using ehci_hcd
Feb 13 13:05:43 002 kernel: usb 1-2: device not accepting address 2, error -110
Feb 13 13:05:43 002 kernel: usb 1-2: reset high-speed USB device number 2 using ehci_hcd
Feb 13 13:05:51 002 sudo[720]: phnx4 : TTY=pts/0 ; PWD=/home/phnx4 ; USER=root ; COMMAND=/usr/bin/journalctl -xb
Feb 13 13:05:51 002 sudo[720]: pam_unix(sudo:session): session opened for user root by phnx4(uid=0)
Feb 13 13:05:53 002 systemd-udevd[97]: worker [120] terminated by signal 9 (Killed)
Feb 13 13:05:53 002 kernel: usb 1-2: device not accepting address 2, error -110
Feb 13 13:05:53 002 kernel: phy0 -> rt2x00usb_vendor_request: Error - Vendor Request 0x07 failed for offset 0x0580 with error -19.
Feb 13 13:05:53 002 kernel: phy0 -> rt2800_init_eeprom: Error - Invalid RT chipset 0xf369 detected.
Feb 13 13:05:53 002 kernel: phy0 -> rt2x00lib_probe_dev: Error - Failed to allocate device.
Feb 13 13:05:53 002 kernel: usbcore: registered new interface driver rt2800usb
Feb 13 13:05:53 002 kernel: hub 3-0:1.0: unable to enumerate USB device on port 1
Feb 13 13:05:53 002 kernel: usb 1-2: USB disconnect, device number 2
Feb 13 13:05:54 002 kernel: usb 1-2: new high-speed USB device number 8 using ehci_hcd
Feb 13 13:06:09 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:06:24 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:06:24 002 kernel: usb 1-2: new high-speed USB device number 9 using ehci_hcd
Feb 13 13:06:39 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:06:55 002 kernel: usb 1-2: device descriptor read/64, error -110
Feb 13 13:06:55 002 kernel: usb 1-2: new high-speed USB device number 10 using ehci_hcd
Feb 13 13:07:05 002 kernel: usb 1-2: device not accepting address 10, error -110
Feb 13 13:07:05 002 kernel: usb 1-2: new high-speed USB device number 11 using ehci_hcd
Feb 13 13:07:16 002 kernel: usb 1-2: device not accepting address 11, error -110
Feb 13 13:07:16 002 kernel: hub 1-0:1.0: unable to enumerate USB device on port 2
Feb 13 13:07:16 002 kernel: usb 2-2: new full-speed USB device number 2 using uhci_hcd
Feb 13 13:07:16 002 kernel: usb 2-2: not running at top speed; connect to a high speed hub
Feb 13 13:07:17 002 kernel: usb 2-2: reset full-speed USB device number 2 using uhci_hcd
Feb 13 13:07:17 002 kernel: ieee80211 phy1: Selected rate control algorithm 'minstrel_ht'
Feb 13 13:07:17 002 kernel: Registered led device: rt2800usb-phy1::radio
Feb 13 13:07:17 002 mtp-probe[1002]: checking bus 2, device 2: "/sys/devices/pci0000:00/0000:00:10.0/usb2/2-2"
Feb 13 13:07:17 002 mtp-probe[1002]: bus: 2, device: 2 was not an MTP device
Feb 13 13:07:17 002 kernel: Registered led device: rt2800usb-phy1::assoc
Feb 13 13:07:17 002 kernel: Registered led device: rt2800usb-phy1::quality
Feb 13 13:07:17 002 kernel: usb 3-2: new low-speed USB device number 3 using uhci_hcd
Feb 13 13:07:17 002 mtp-probe[1024]: checking bus 3, device 3: "/sys/devices/pci0000:00/0000:00:10.1/usb3/3-2"
Feb 13 13:07:17 002 mtp-probe[1024]: bus: 3, device: 3 was not an MTP device
Feb 13 13:07:17 002 kernel: usbcore: registered new interface driver usbhid
Feb 13 13:07:17 002 kernel: usbhid: USB HID core driver
Feb 13 13:07:17 002 kernel: input: Logitech USB-PS/2 Optical Mouse as /devices/pci0000:00/0000:00:10.1/usb3/3-2/3-2:1.0/input/input4
I have no clue what this means.
Here is the complete systemd journal (journalctl -b): http://sprunge.us/PdRZ.
When scrolling through the journal, I noticed the following as well:
Feb 13 13:03:41 002 systemd-fsck[181]: /dev/sdb7: clean, 85/1193696 files, 788437/4757240 blocks
Feb 13 13:03:41 002 kernel: codec_read: codec 0 is not valid [0x107e5370]
Feb 13 13:03:41 002 kernel: codec_read: codec 0 is not valid [0x107e5370]
Feb 13 13:03:41 002 kernel: codec_read: codec 0 is not valid [0x107e5370]
Feb 13 13:03:41 002 kernel: codec_read: codec 0 is not valid [0x107e5370]
Feb 13 13:03:41 002 systemd[1]: Started File System Check on /dev/sdb7.
-- Subject: Unit systemd-fsck@dev-sdb7.service has finished start-up
-- Defined-By: systemd
-- Support: http://lists.freedesktop.org/mailman/li … temd-devel
-- Documentation: http://www.freedesktop.org/wiki/Softwar … 6248231fbf
--
-- Unit systemd-fsck@dev-sdb7.service has finished starting up.
--
-- The start-up result is done.
Feb 13 13:03:41 002 systemd[1]: Mounting /mnt/b7...
-- Subject: Unit mnt-b7.mount has begun with start-up
-- Defined-By: systemd
-- Support: http://lists.freedesktop.org/mailman/li … temd-devel
-- Documentation: http://www.freedesktop.org/wiki/Softwar … dc7b36dcc5
--
-- Unit mnt-b7.mount has begun starting up.
Is this related to the problem with the usb or is this something different?
Offline
When I remove the usb dongle (Belkin Components, F5D8053 N Wireless USB Adapter v3000 [Ralink RT2870]), the problem disappears. The mouse works without any problem now. The codec_read boot messages are still there.
The usb dongle doesn't cause any problems when I boot into the Archlinux system on my second HD. This seems to rule out a hardware problem with the usb dongle.
Offline