You are not logged in.
Pages: 1
I installed base Arch on one of my hard drives (other has debian) by ftp without a problem. When I went to install further packages on reboot (and dhcpcd) pacman worked with no problem then after a very short period stopped mid download. My ethernet card is shown in lspci and lsmod and ifconfig show the eth0. dhcpcd appears to be running but when I ctrl c out of pacman I cannot ping isp.
I've searched and noticed others have same problem but I never see a solution.
Any ideas?
Thanks
jrc
Part of dmseg
Linux Tulip driver version 1.1.13 (May 11, 2002)
ACPI: PCI Interrupt 0000:02:0b.0[A] -> GSI 23 (level, low) -> IRQ 17
tulip0: EEPROM default media type Autosense.
tulip0: Index #0 - Media MII (#11) described by a 21140 MII PHY (1) block.
tulip0: Index #1 - Media 10baseT (#0) described by a 21140 non-MII (0) block.
tulip0: Index #2 - Media 100baseTx (#3) described by a 21140 non-MII (0) block.
tulip0: Index #3 - Media 10baseT-FDX (#4) described by a 21140 non-MII (0) block.
tulip0: Index #4 - Media 100baseTx-FDX (#5) described by a 21140 non-MII (0) block.
tulip0: MII transceiver #1 config 3100 status 7809 advertising 01e1.
eth0: Davicom DM9102/DM9102A rev 49 at 0001d800, 00:08:A1:08:80:37, IRQ 17.
Real Time Clock Driver v1.12
input: PC Speaker
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378, irq 7 [PCSPP,TRISTATE,EPP]
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
eth0: Setting full-duplex based on MII#1 link partner capability of 45e1.
eth0: no IPv6 routers present
0000:02:0b.0: tulip_stop_rxtx() failed
JRC
Offline
I figured it out. Silly me needed to insert ethernet card in modules in rc.conf
JRC
Offline
I figured it out. My bad. Needed to insert ethernet card in modules in rc.conf
JRC
Offline
Pages: 1