You are not logged in.
I've encountered a strange error with my new monitor / graphics card.
If I leave the computer on the monitor goes idle - and wakes up when i move the mouse / touch the keyboard (as expected).
But if I turn of the monitor by pressing the power button (on the monitor) I can't wake it up again - the monitor reports "DisplayPort: No signal" and then goes idle.
I've tried:
* "hard" rebooting the screen (unplugging the power)
* Switching between different TTYs and X (I know I'm in X and the computer is responding)
* Restarting X (switching to TTY1 -> Ctrl-C and then run startx)
* Unplugging the DP-cable and plug it back in
* Plugin a DVI-cable instead of DP
Any suggestions on what to search for / what could cause this problem?
The monitor is a: ASUS PB278
My graphic card is a: XFX Radeon HD7770
Offline
I know this is very old but in case someone else has this same issue as I did the fix was actually rather simple when you realize the problem. DisplayPort has a weird issue regardless of the monitor because some motherboards stop sending the signal when the monitor is turned off due to a "power saver" feature in the monitors.
I have an HP Monitor that had this issue and I found out that Samsung also has something similar when it comes to their monitors. I don't know about ASUS but I think it is safe to assume that it might be an issue with DisplayPort itself rather than the manufacturers.
Here are the solutions I found, this forces the monitor to use the original signal so it doesn't need to be resent to the monitor.
HP:
Monitor Menu -> Source Detection -> Low Power (Power Saver) -> change to "Always Active".
Samsung:
Monitor Menu -> Setup & Reset -> Magic Return -> off
ASUS: (not tested, just a hypothesis)
Monitor Menu -> System Settings -> ECO Mode -> turn off
Last edited by MichaelTunnell (2014-07-28 16:57:43)
Offline