You are not logged in.

#1 2013-04-05 23:38:26

djringjr
Member
Registered: 2013-04-05
Posts: 8

HPLIP network printer installs OK, but refuses to print, error code=12

I searched all over the Internet for an answer to this and nothing worked, until I bumbled across the answer - policy!

hp-setup -i was able to set up OK but printer failed to work.
hplip error: Unable to communicate with device (code=12)

hp-doctor (accept the errors about arch not being supported and continue to run) reports everything is fine - all compile and run dependencies, but it won't connect.]

Run in terminal as non-root user:

system-config-printer

You should see icons showing the installed printers.

Right click the printer icon.  Select "Enable".

If this is an ALL IN ONE with a "fax" printer, do the same for that icon.

You should power off your computer, reboot, and do the same for your printer, just to be sure everything gets started correctly.

Also in system-config-printer there is an excellent troubleshooter for printer troubles.

SOLVED.

David

Offline

#2 2013-04-05 23:39:04

djringjr
Member
Registered: 2013-04-05
Posts: 8

Re: HPLIP network printer installs OK, but refuses to print, error code=12

Mark solved.

Offline

Board footer

Powered by FluxBB