You are not logged in.

#1 2013-04-06 14:58:32

bergqvistjl
Member
Registered: 2011-01-05
Posts: 41

How can I make a udev rule to remap an rc0 device to another number?

Hi, I currently have two rc devices automatically being detected, an rc0 device with the driver of: "saa716x", and an rc1 device, with an "mceusb" driver. I would like to essentially swap these devices around (or just disable the saa716x device even), so that on rc0 I have the mceusb device. How can I do this? I was told to make a udev rule but everything i've tried isn't working. Any ideas? Thanks

Offline

Board footer

Powered by FluxBB