You are not logged in.

#1 2013-04-15 22:09:13

vvd
Member
Registered: 2008-08-07
Posts: 20

cpupower.service sometimes fails to apply configuration

cpupower.service sometimes fails to apply it's configuration at boot. It works as expected when manually applied from the onsole (systemctl restart cpupower). Has anyone experienced this and found the cause/a solution? This is my /etc/default/cpupower:

# Define CPUs governor
# valid governors: ondemand, performance, powersave, conservative, userspace.
governor='ondemand'

# Limit frequency range
# Valid suffixes: Hz, kHz (default), MHz, GHz, THz
min_freq="2.20GHz"
max_freq="3.20GHz"

# Specific frequency to be set.
# Requires userspace governor to be available.
# Do not set governor field if you use this one.
#freq=

# Utilizes cores in one processor package/socket first before processes are 
# scheduled to other processor packages/sockets.
# See man (1) CPUPOWER-SET for additional details.
#mc_scheduler=

# Utilizes thread siblings of one processor core first before processes are
# scheduled to other cores. See man (1) CPUPOWER-SET for additional details.
#smp_scheduler=

#  Sets a register on supported Intel processore which allows software to convey
# its policy for the relative importance of performance versus energy savings to
# the  processor. See man (1) CPUPOWER-SET for additional details.
#perf_bias=

# vim:set ts=2 sw=2 ft=sh et:

ThankYou


I am an evil patriARCH, peach!

Offline

#2 2013-04-16 22:27:37

dodo3773
Member
Registered: 2011-03-17
Posts: 820

Re: cpupower.service sometimes fails to apply configuration

I am having the same issue. If I start it manually after with systemctl it works just fine though.

Offline

Board footer

Powered by FluxBB