You are not logged in.
After following http://mcaf.ee/rqaln (arch-wiki) and doing
creating with cvt
cvt 1600 900
1600x900 59.95 Hz (CVT 1.44M9) hsync: 55.99 kHz; pclk: 118.25 MHz
Modeline [b]"1600x900_60.00" 118.25 1600 1696 1856 2112 900 903 908 934 -hsync +vsync[/b]making
xrandr [b]--newmode[/b] [b]"1600x900_60.00" 118.25 1600 1696 1856 2112 900 903 908 934 -hsync +vsync[/b]Adding
xrandr --addmode [b]VGA1[/b] [b]"1600x900_60.00"[/b]Changing
xrandr --output [b]VGA1[/b] [b]--mode "1600x900_60.00"[/b]I found out with one reboot all of the will go. so i did
my /etc/X11/xorg.conf
Section "Device"
Identifier "Intel Xeon"
Option "Monitor-VGA1" "VGA screen"
EndSection
Section "Monitor"
Identifier "VGA screen"
Modeline "1600x900_60.00" 118.25 1600 1696 1856 2112 900 903 908 934 -Hsync +Vsync
Option "PreferredMode" "1600x900"
EndSection
Section "Screen"
Identifier "Primary Screen"
Device "Intel Xeon"
DefaultDepth 24
SubSection "Display"
Depth 24
Modes "1600x900"
EndSubSection
EndSectionBut there is no use after all this work. the restart will undo all the work. even the 1600*900 will disappear from the xrandr command output
How could i make it Persistent
Last edited by krax (2013-07-21 16:21:05)
Offline
Hello krax
You didn't give a Driver line in the Section "Device" of your /etc/X11/xorg.conf:
Section "Device"
Identifier "Intel Xeon"
Driver "........." <--------------------------you need a driver there
Option "Monitor-VGA1" "VGA screen" <-----------------I don't think these are valid options
EndSectionAlso try to add the '_60.00' suffix to all the "1600x900" references.
And look into the /var/log/Xorg.0.log file to see what happens.
Good luck.
Offline