Arch Linux

dakoellis

Member

Registered: 2013-03-15

Posts: 22

Wacom Bamboo Capture Multitouch Help

Hi All,

I have a Wacom Bamboo Capture that I am trying to get working again to support all the multitouch I use.  In the past, I was using xsetwacom --set ID "Gesture" off, then running touchegg, and it would give me everything up to 5 point gestures working perfectly (besides in overlay mode).  I did a system update, and now when I use the xsetwacom command, the pointer doesn't move anymore.  I can still use a mouse to move, as well as the pen, but touch doesn't move it anymore.  Gestures still work as well after I run touchegg.  The only problem at this point is the movement of the pointer using my finger on the pad.  can anyone provide some insight?

EDIT: I forgot to mention that the pointer does move if I turn Gesture back on, but when it is off, there is no movement.  it doesn't matter which ID I use, it will still stop the mouse movement.

Thanks a bunch!

Last edited by dakoellis (2013-08-13 18:51:26)