You are not logged in.
Hello,
I bought a Korean 1440p monitor a few days ago (QNIX QX2710). During my research before buying it, I found that it needs a custom xorg.conf. The monitor works great with my xorg.conf (http://tny.cz/3be30d29) and KDE, which is my main desktop.
Now I wanted to see how Gnome 3.8 looks on this monitor. I installed it with pacman -S gnome and started it through KDM and got this screen.
I can still switch to TTY and stop kdm and start it again. If I log into KDE there is no problem. I tried using GDM, but it suffers from the same image corruption. The PC basically boots straight into the glitch.
What could cause that? The monitor, driver and X11 seem to work flawlessly, just not with Gnome. The graphics card used is a GTX 580 with 325.15 driver. Monitor is connected with Dual-Link DVI.
Kind regards,
blackout23
UPDATE: The problem was that Gnome doesn't honor xorg.conf and does its own display configuration, which set 1024x768 on this monitor. xrandr reports this as first resolution before 2560x1440, despite being unsupported. I logged into the PC as root over SSH while the display was glitchy and turned of the display: "DISPLAY=:0 xrandr --outut DVI-I-2 --off" and set a proper mode "DISPLAY=:0 xrandr --outut DVI-I-2 --mode 2560x1440 --rate 60". This would make GDM show up. Upon the logging in the screen would scramble again. Now I logged out of SSH and connected as regular user with SSH and did the same thing. On the Gnome Desktop I opened the display configuration in the control center and set the the resolution to 2048x1546 and back to 2560x1440 and applied the change. This created monitors.xml in ~/.config which I copied to /var/lib/gdm/.config. Now Gnome starts up as expected.
Last edited by blackout23 (2013-10-14 17:25:43)
Offline