You are not logged in.

#1 2013-09-20 04:07:31

wakadaka
Member
Registered: 2013-09-20
Posts: 1

A few Openbox + dual-screen questions

Hello all, I have a few issues with correctly running a dual-screen setup with Openbox on my laptop. If I have posted this in the wrong forum, I apologize.

I'm running an Openbox setup with a Bumblebee/nVidia driver combo. This works wonderfully until I plug my HDTV (monitor) in to act as a second screen. The system recognizes the monitor immediately and I have no problems using xrandr to get the two displays functioning in the configuration that I want them (HDTV above LVDS1). My main issue here is the behavior of the windows as I start to use my system after configuration. For example, I'll be browsing in Chromium with multiple tabs and as soon as I click another tab, the entire window will move so that about a third of the window displays on the HDTV on top and the rest of the window displays cut-off on the bottom LVDS1. Also, upon maximization of any window on LVDS1, only the titlebar will show and the rest of the window is absent. Has anyone else had these problems before? I've tried searching, but I have found nothing useful for solving this issue.

Also, if anyone has any suggestions on how to get Flash to stay fullscreen on my second monitor (the top HDTV) while I work on other things, they would be greatly appreciated. Thanks!

Offline

#2 2013-09-20 06:58:14

bjornoslav
Member
Registered: 2011-11-01
Posts: 137

Re: A few Openbox + dual-screen questions

For best results, I think you should be using the nVidia control center for setting up multiple displays, or if you're using xrandr try setting the second output screen to the left, under or below the primary one, but not to the right (there are switches about it, chech out xrandr's man page).


asus ux303la, core i5@1.6ghz, 8 gb ram, 500gb hdd, hd4400 gpu, crux x64 with openbox

Offline

Board footer

Powered by FluxBB