You are not logged in.

#1 2013-11-12 07:41:06

Ree
Member
Registered: 2010-05-19
Posts: 37

Inconsolata bold

I have installed the Inconsolata font which is nice but there is a problem - bold characters are wider than regular characters. This creates a lot of problems, for example, bold words are cut off in Konsole. Is there a way to make the font monospaced?

Offline

#2 2013-11-12 16:06:41

WonderWoofy
Member
From: Los Gatos, CA
Registered: 2012-05-19
Posts: 8,414

Re: Inconsolata bold

I use bohoomil's t1-inconsolata-zi4-ibx font from his infinality-bundle-fonts repo.  I have been using it for quite some time in my terminals, and checking in gtk2fontsel, it appears that this font stays a consistent width between regular and bold...

If you don't already know about it, bohoomil provides his excellent infinality-bundle font configurations as well as a whole collection of free fonts in his infinality-bundle-fonts repo.  He does an absolutely amazing job at pre-configuring fonts like I have never seen on Linux before.  I used to think that it would be nice to learn how to configure fonts myself, but after looking into it a little, it seemed like a real PITA.  That is when I reached out to bohoomil and discovered his amazing font fascination and configuration abilities.  Give it a whirl!  There is a wiki page describing the steps necessary to get it working[0].

[0] https://wiki.archlinux.org/index.php/In … le%2Bfonts

Offline

Board footer

Powered by FluxBB