You are not logged in.
Have installed and un-installed several times, get the same result every time, UFW won't start on bootup.
# ufw enable
Command may disrupt existing ssh connections. Proceed with operation (y|n)? y
Firewall is active and enabled on system startup
# ufw status
Status: active
To Action From
-- ------ ----
22 ALLOW Anywhere
10000 ALLOW Anywhere
1723 ALLOW Anywhere
22 ALLOW Anywhere (v6)
10000 ALLOW Anywhere (v6)
1723 ALLOW Anywhere (v6)
#rebootAfter reboot:
# ufw status
Status: inactiveAlso, "systemctl enable ufw" does not fixit.
What am I doing wrong ??
Thanks
PeterC
Offline
What was the output of "systemctl enable ufw"?
What does the journal tell you is happening?
All men have stood for freedom...
For freedom is the man that will turn the world upside down.
Gerrard Winstanley.
Offline
Hi,
Many thanks for helping, here's the output:
# systemctl enable ufw
# systemctl start ufw
# systemctl status ufw
ufw.service - CLI Netfilter Manager
Loaded: loaded (/usr/lib/systemd/system/ufw.service; enabled)
Active: active (exited) since Fri 2013-11-29 12:21:21 UTC; 24min ago
Main PID: 125 (code=exited, status=0/SUCCESS)
Nov 29 12:21:21 systemd[1]: Started CLI Netfilter Manager.
Nov 29 12:45:30 systemd[1]: Started CLI Netfilter Manager.
# ufw status
Status: inactivestatus suggests it started successfully and exited 0 ?!
Offline
Did you check this thread and eliminate the issue described as being the cause?
All men have stood for freedom...
For freedom is the man that will turn the world upside down.
Gerrard Winstanley.
Offline