You are not logged in.

#1 2013-12-03 23:50:47

Ave6
Member
Registered: 2013-08-27
Posts: 9

[BSPWM] Issues with my windows being the wrong shape for my monitor.

I wasn't sure what to name this, but I guess that doesn't matter. 
 
 
Simple backstory: I'm running arch on my laptop. I used to run a dual monitor setup (my laptop's screen and an external monitor); however, as of a little while ago, the laptop's screen broke, leaving me to use the external monitor only. 
 
The issue is that, in bspwm, the windows that are made are for the size and shape of the laptop's monitor...  not the external monitor.   
(As you can see here.[That is just a screenshot of what happens when I press the shortcut to pull up my terminal]) 
   
To set the external monitor as the monitor shown and used I use xrandr with this in my xinitrc: 

xrandr --output HDMI1 --off --output LVDS1 --off --output DP2 --off --output DP1 --off --output --primary VGA1 --mode 1280x1024 --pos 0x0 --rotate normal &

 
If there is anything else you need to know, tell me... I'm not exactly sure what the issue is here, but I'm really hoping someone here does.

Offline

#2 2013-12-05 11:25:26

bloom
Member
Registered: 2010-08-18
Posts: 749
Website

Re: [BSPWM] Issues with my windows being the wrong shape for my monitor.

This:

bspc config remove_disabled_monitor true

might help.


gh · da · ds

Offline

Board footer

Powered by FluxBB