You are not logged in.
Ive got this boring problem: at every boot, my ipw2200 gets recognized as a different device: 1 time as eth0, 1 time as eth1.
The strange thing is that this begun to happen only today after updating all packages from testing. This would not be a big problem, but since im using network profiles, every 2nd boot the network profile cant be started, as it is using the wrong device. Any clue?
eth0 unassociated ESSID:off/any
Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00
Bit Rate=0 kb/s Tx-Power=20 dBm
Retry limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
eth1 IEEE 802.11g ESSID:"honzor"
Mode:Managed Frequency:2.412 GHz Access Point: 00:13:D4:E8:53:8D
Bit Rate=54 Mb/s Tx-Power=20 dBm
Retry limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=96/100 Signal level=-29 dBm Noise level=-88 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Offline
I knew I saw this somewhere before... very recent post on the subject here: http://bbs.archlinux.org/viewtopic.php? … +interface
Offline
Thank you, seems like i dint dig around enough here
Offline