You are not logged in.

#1 2014-03-07 15:50:58

Hellrespawn
Member
From: The Netherlands
Registered: 2011-10-17
Posts: 9
Website

[Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

Edit: When using the latest mainline kernel from here (3.14rc5 at the time of writing) all the problems go away. I'm hoping that this means I simply have to wait for 3.14 to release and hit [core] eventually. Also, my system clock *was* set incorrectly, because "ntpd -q" didn't print any sort of warning when I forgot the "-g" parameter.

Original message preserved in case anyone has the same problem:
On a fresh install, if I boot the latest kernel (3.13.5-1 at the time of writing) booting will stop midway through the systemd startup sequence. The specific line it ends on varies, sometimes it's "Starting Sound Card", other times it's "Starting Load/Save Random Seed." The system cursor stop blinking.

Adding debug to my boot parameters gives a large number of errors along the line of "Assertion: dual_timestamp_is_set has failed in sd_event_now_get_monotonic".
After this boot continues for a while, before freezing as described, without any sort of error or noteworthy output (as far as I can tell.)

Using the latest lts kernel (3.10.32-1) boot does finish, although it gives the same Assertion error as above. Also, the i915 module gives the error "preliminary hardware support disabled" and no modesetting is done. When trying to start X there are "No screens found"

As far as I can tell, the system clock and all related config files are configured correctly. All packages are up to date.

The system is an Intel NUC DN2820FYKH with a Bay Trail Celeron N2820 processor. For full specs:
http://www.intel.com/content/www/us/en/ … 0fykh.html

Last edited by Hellrespawn (2014-03-08 21:13:53)

Offline

#2 2014-03-08 17:25:21

Dfects
Member
Registered: 2014-02-24
Posts: 3

Re: [Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

I have the same device, with the same issues. I've never tried to use X server though so can't confirm that. I just tried 3.13.6 and its not booting again. Its running headless and haven't had chance to plug in a display yet but it seems to of caused the same or similar issue.

Offline

#3 2014-03-08 18:21:16

Dfects
Member
Registered: 2014-02-24
Posts: 3

Re: [Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

Heres what I see after everything > 3.12.9 . It has a blinking cursor underneath that freezes, hdd light then stays on solid and doesn't do anything.

IMG_20140308_181400.jpg

Offline

#4 2014-03-08 21:14:20

Hellrespawn
Member
From: The Netherlands
Registered: 2011-10-17
Posts: 9
Website

Re: [Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

Sort of solved it, see first post.

Offline

#5 2015-12-01 22:43:46

hackeron
Member
Registered: 2015-12-01
Posts: 1

Re: [Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

Is there any cause or better solution? - I'm experiencing the same issue on Ubuntu 15.10 - https://bugs.launchpad.net/ubuntu/+sour … ug/1521749

Offline

#6 2015-12-04 09:22:26

WorMzy
Forum Moderator
From: Scotland
Registered: 2010-06-16
Posts: 11,784
Website

Re: [Solved/Workaround] System freeze during boot on Intel NUC DN2820FYKH

hackeron, please seek support on your own distro's forums; these forums are for Arch Linux support only.

Closing.


Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD

Making lemonade from lemons since 2015.

Offline

Board footer

Powered by FluxBB