Arch Linux

mrDoctorWho

Member

From: TARDIS

Registered: 2014-07-05

Posts: 7

Seagate external hdd won't be shown in devices to mount in userspace

Hello there.

When i connect my external hdd (usb 3.0), it won't be shown in devices to mount in filemanager. But with another usb devices such as flash-drives and another external hdd all is ok.

Here is dmesg:

28.017643] fuse init (API version 7.23)
[   87.354621] usb 2-2: new SuperSpeed USB device number 2 using xhci_hcd
[   87.380188] usbcore: registered new interface driver usb-storage
[   87.383531] scsi6 : uas
[   87.383666] usbcore: registered new interface driver uas
[   87.384759] scsi 6:0:0:0: Direct-Access     Seagate  Backup+  BK      0143 PQ: 0 ANSI: 6
[   87.386889] sd 6:0:0:0: [sdb] Spinning up disk...
[   91.302123] .ready
[   91.302456] sd 6:0:0:0: [sdb] 1953525167 512-byte logical blocks: (1.00 TB/931 GiB)
[   91.303658] sd 6:0:0:0: [sdb] Write Protect is off
[   91.303667] sd 6:0:0:0: [sdb] Mode Sense: 2b 00 10 08
[   91.304490] sd 6:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA
[   91.330276]  sdb: sdb1
[   91.333493] sd 6:0:0:0: [sdb] Attached SCSI disk
[   99.464742] sd 6:0:0:0: [sdb] uas_eh_abort_handler ffff8800a815a000 tag 0, inflight: CMD IN
[  102.468181] scsi host6: uas_eh_task_mgmt: ABORT TASK timed out

I also tried this HDD in Ubuntu, there's all fine.

l0vot

Member

Registered: 2011-08-26

Posts: 117

Re: Seagate external hdd won't be shown in devices to mount in userspace

Start gparted and see if it shows up. Also blkid should list the drive if it can be picked up at all.

mrDoctorWho

Member

From: TARDIS

Registered: 2014-07-05

Posts: 7

Re: Seagate external hdd won't be shown in devices to mount in userspace

Yes, after running gparted and about 40 seconds it shows up.