You are not logged in.

#1 2014-08-10 03:15:50

jmak
Member
Registered: 2008-12-21
Posts: 453

X doesn't start after update

Hello,

After updating the system X won't start. This is the error message I get when launch startx

[    20.984] (II) config/udev: Adding input device HDA ATI SB Front Headphone (/dev/input/event9)
[    20.984] (II) AutoAddDevices is off - not adding device.
[    20.985] (II) config/udev: Adding input device AT Translated Set 2 keyboard (/dev/input/event0)
[    20.985] (II) AutoAddDevices is off - not adding device.
[    20.985] (II) config/udev: Adding input device PC Speaker (/dev/input/event4)
[    20.985] (II) AutoAddDevices is off - not adding device.
[    21.218] (II) UnloadModule: "kbd"
[    21.218] (II) UnloadModule: "mouse"
[    21.855] (II) NVIDIA(GPU-0): Deleting GPU-0
[    21.886] (EE) Server terminated successfully (0). Closing log file.

Graphic card:

01:00.0 VGA compatible controller: NVIDIA Corporation G84 [GeForce 8400 GS] (rev a1) (prog-if 00 [VGA controller])
	Flags: bus master, fast devsel, latency 0, IRQ 43
	Memory at fa000000 (32-bit, non-prefetchable) [size=16M]
	Memory at d0000000 (64-bit, prefetchable) [size=256M]
	Memory at f8000000 (64-bit, non-prefetchable) [size=32M]
	I/O ports at df00 [size=128]
	[virtual] Expansion ROM at fbfe0000 [disabled] [size=128K]
	Capabilities: <access denied>
	Kernel driver in use: nvidia
	Kernel modules: nouveau, nvidia

I have the same setup on a different partition and I updated that one too without problem.

Any idea?

Last edited by jmak (2014-08-10 03:36:18)

Offline

Board footer

Powered by FluxBB