Arch Linux

erkexzcx

Banned

From: Kaunas

Registered: 2014-09-28

Posts: 77

alsa/pulseaudio - keep the same master volume for speaker&headphones

Hello,

I have laptop Asus N550JV.

I installed alsa ant pulseaudio (alsa-utils and pulseaudio, nothing else, no pulseaudio-alsa plugin, because I noticed that it causes me more problems rather than reduces them.

the problem is that I want to keep Master audio channel untouched. If I listen through speaker, I could set master volume to 50%, then I can plug in headphones, set volume to 100%, then I can unplug headphones, the sound will play still at 100% THROUGH SPEAKER for about 0.5 sec. and after 0.5sec it will set back to 50% as I set when I was listening through speakers.

My question is, how can I fix this problem. I see that there are 2 ways to fix this:

1. make a lag time (delay) to switch from headphones to speakers.
2. keep the same master audio volume for both headphones and speakers.

Any ideas? I think the second solution would be easier to make, but I dunno how

---

Allergic to admins&moderators. They scare me.