You are not logged in.
I'm using Gnome 3.16.2 and bluez-git from https://gist.github.com/ntzrmtthihu777/ … 631f5782f8.
Kernel 4.1.6-1-ARCH x86_64 GNU/Linux
My motherboard is a Z97I and it comes with a built-in Broadcom BCM4352 Wireless Network Adapter. The same adapter from Dell XPS 13 2015.
Wi-Fi is working fine after installing broadcom-wl-dkms and b43-firmware from AUR.
The Bluetooth was identified by the system and I can use bluetoothctl to power on and do the other commands.
However, it is actually not working, if I put this in discovery mode, it can't find any device or even been found by other devices.
Tried with 3 different devices and my phone.
I also tried to manual extract the firmware with cabextract, as pointed in this wiki https://wiki.archlinux.org/index.php/De … #Bluetooth. However, without success.
I was running into some errors in bluez service itself, so I have installed the bluez-git from the gist I have provided in the beginning of the post. Also, without success.
Now, the only error I'm receiving from the bluetooth daemon is:
RFCOMM server failed for Headset Voice gateway: rfcomm_bind: Address already in use (98)This could be related with the discovery mode issue? Or should I start to dig in different places?
Last edited by ayr-ton (2015-11-26 23:16:26)
Fork it all! Fork it all!
Offline
After two updates of broadcom-wl-dkms, b43-firmware and bluez4-git, the issue persists.
Fork it all! Fork it all!
Offline
Was fixed at the last updates at b43-firmware from AUR.
Fork it all! Fork it all!
Offline