You are not logged in.
Pages: 1
Hey, guys!
After the last week updates I noticed some messages in red during boot. I am not saying the updates caused them and actually everything works fine but if there is a way to clear those messages I will feel better.
Here is the output
systemctl --failed
UNIT LOAD ACTIVE SUB DESCRIPTION
● pwmfrequency@0x05000500.service loaded failed failed LED PWM frequency
● pwmfrequency@0x07a107a1.service loaded failed failed LED PWM frequency
● pwmfrequency@0x43d043d.service loaded failed failed LED PWM frequency
● pwmfrequency@0x7a107a1.service loaded failed failed LED PWM frequency
LOAD = Reflects whether the unit definition was properly loaded.
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
SUB = The low-level unit activation state, values depend on unit type.
4 loaded units listed. Pass --all to see loaded but inactive units, too.
To show all installed unit files use 'systemctl list-unit-files'.
intel_reg_write 0xC8254 0x7a107a1
-bash: intel_reg_write: command not found
I have the pwmfrequency@.service file in /etc/systemd/system following the instructions here https://wiki.archlinux.org/index.php/ba … 15_only.29 and here http://devbraindom.blogspot.com/2013/03 … intel.html and the current frequency is set to 500 Hz.
Any help is highly appreciated!
Thank you!
Offline
Pages: 1