You are not logged in.
Hi,
Here is my problem, last night i shutdown my computer with wifi turn off, and this morning, i can't get the wifi to work.
Its probably related to that, or probably to my last update.
Here is some commands that may help you :
> uname -a
Linux localhost.localdomain 4.3.3-3-ARCH #1 SMP PREEMPT Wed Jan 20 08:12:23 CET 2016 x86_64 GNU/Linux
> lspci -k | grep -i net -A 2
02:00.0 Network controller: Broadcom Corporation BCM43142 802.11b/g/n (rev 01)
Subsystem: Foxconn International, Inc. Device e07e
Kernel modules: bcma
--
03:00.1 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 12)
Subsystem: Acer Incorporated [ALI] Device 0934
Kernel driver in use: r8169
> rfkill list
0: acer-wireless: Wireless LAN
Soft blocked: no
Hard blocked: no
1: acer-bluetooth: Bluetooth
Soft blocked: yes
Hard blocked: no
sudo wifi-menu
Mot de passe [sudo] de kaldoran :
Invalid interface specification
[...]
> sudo netctl start /etc/netctl/wlp2s0-cbjmmaison
Job for netctl@-etc-netctl-wlp2s0\x2dcbjmmaison.service failed because the control process exited with error code. See "systemctl status "netctl@-etc-netctl-wlp2s0\\x2dcbjmmaison.service"" and "journalctl -xe" for details.
> systemctl status "netctl@-etc-netctl-wlp2s0\\x2dcbjmmaison.service" -l
● netctl@-etc-netctl-wlp2s0\x2dcbjmmaison.service - Networking for netctl profile /etc/netctl/wlp2s0-cbjmmaison
Loaded: loaded (/usr/lib/systemd/system/netctl@.service; static; vendor preset: disabled)
Active: failed (Result: exit-code) since ven. 2016-01-22 13:56:57 EST; 55s ago
Docs: man:netctl.profile(5)
Process: 1226 ExecStart=/usr/lib/network/network start %I (code=exited, status=1/FAILURE)
Main PID: 1226 (code=exited, status=1/FAILURE)
janv. 22 13:56:57 localhost.localdomain systemd[1]: Starting Networking for netctl profile /etc/netctl/wlp2s0-cbjmmaison...
janv. 22 13:56:57 localhost.localdomain network[1226]: Profile '/etc/netctl/wlp2s0-cbjmmaison' does not exist or is not readable
janv. 22 13:56:57 localhost.localdomain systemd[1]: netctl@-etc-netctl-wlp2s0\x2dcbjmmaison.service: Main process exited, code=exited, status=1/FAILURE
janv. 22 13:56:57 localhost.localdomain systemd[1]: Failed to start Networking for netctl profile /etc/netctl/wlp2s0-cbjmmaison.
janv. 22 13:56:57 localhost.localdomain systemd[1]: netctl@-etc-netctl-wlp2s0\x2dcbjmmaison.service: Unit entered failed state.
janv. 22 13:56:57 localhost.localdomain systemd[1]: netctl@-etc-netctl-wlp2s0\x2dcbjmmaison.service: Failed with result 'exit-code'.
> sudo cat /etc/netctl/wlp2s0-cbjmmaison
Description='Automatically generated profile by wifi-menu'
Interface=wlp2s0
Connection=wireless
Security=wpa
ESSID=cbjmmaison
IP=dhcp
Key=<password of network (im sure of it)>
ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default
2: enp3s0f1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN mode DEFAULT group default qlen 1000
6: enp0s20u2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UNKNOWN mode DEFAULT group default qlen 1000
I hope i do not forget anything that may help you. If so, just ask i will add the commands output.
Thanks.
Ps : Btw i've tried to disable tlp but that's seams that not the problem.
And tried to reboot 3 - 4 times too
Last edited by kaldøran (2016-01-22 20:22:33)
Offline
From reading the title, I thought this could be much worse. But the only problem is an rf-kill softblock. You should be able to `rfkill unblock all` and you may be set.
"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" - Richard Stallman
Online
There is only a soft block on the bluetooth, and none on the wireless
Btw i can't see my wifi neither in param configuration, not in panel
Last edited by kaldøran (2016-01-22 19:46:53)
Offline
Oops! Sorry, I misread.
Looking more closely, it seems you do not have a driver for your card. I believe that card is only supported by wl. If you installed wl from the AUR, you may need to rebuild it if there was a kernel (or other dependency) upgrade.
What driver were you previously using?
"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" - Richard Stallman
Online
It seams that i was using "broadcom-wl-dkms
Cause i've tried to install "broadcom-wl" from AUR right now and here is the output :
chargement des paquets...
résolution des dépendances...
recherche des conflits entre paquets...
:: broadcom-wl et broadcom-wl-dkms sont en conflit. Supprimer broadcom-wl-dkms ? [o/N]
There is a conflict between both.
Edit : So i've installed the "broadcom-wl' and remove the "broadcom-wl-dkms" and reboot .. and Voila Wifi is back !
Thanks !!
Edit bis : "If you are using broadcom-wlAUR, uninstall and reinstall it after upgrading your kernel. "
According to https://wiki.archlinux.org/index.php/broadcom_wireless.
So seams to be the same for the "dkms" version. (well i'll tried to remember for the next kernel udapte)
Last edited by kaldøran (2016-01-22 20:16:28)
Offline
I believe dkms are supposed to "rebuild" themselves with kernel upgrades to avoid just this sort of situation. Perhaps something went wrong. Or perhaps dkms isn't quite what I thought: I don't have any first hand experience.
"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" - Richard Stallman
Online
# systemctl enable dkms
Offline