You are not logged in.
hi every body
i want to record some series of video-casts for bbs.archusers.ir and i have some problem:
1-i use KAZAM to record video and audio simultansly but the recorded video has "very low" sound so i hardly hear my voice.
2- i decied to try ffmpeg and walk throgh:
here
but output sound is very low
i use this code to record:
ffmpeg -video_size 1024x768 -framerate 25 -f x11grab -i :0 -f pulse -ac 2 -i default output.mkv
and this is my default sample rate:
[saeed@saeed ~]$ grep "default-sample-rate" /etc/pulse/daemon.conf
default-sample-rate = 96000
any idea?
thanks so much..
Last edited by stackoverflow (2016-03-22 12:03:03)
Offline
Hello!
If you use pulseAudio with Alsa:
- What is your audio recording levels set at in "alsamixer"?
If you use pulseAudio with oss:
- What is your audio recording levels set at in "ossmix"?
Regards
Martin
Last edited by onslow77 (2016-03-26 06:23:45)
It is advised to follow the How to post guide when posting on the Arch forum. If one consciously jumps over these elementary steps like reading the wiki and providing necessary information about the problem, one can be regarded as a Help Vampire.
Offline
Buy a decent microphone. If you are using a standard USB headset-type setup, it will sound terrible, irrespective of what system settings you use.
Offline
Buy a decent microphone. If you are using a standard USB headset-type setup, it will sound terrible, irrespective of what system settings you use.
Hello jasonwryan!
No matter what microphone he/she uses the recording levels must be sat at a correct level. A good microphone can not compensate for wrong input levels.
Regards
Martin
Last edited by onslow77 (2016-03-26 06:36:52)
It is advised to follow the How to post guide when posting on the Arch forum. If one consciously jumps over these elementary steps like reading the wiki and providing necessary information about the problem, one can be regarded as a Help Vampire.
Offline