Arch Linux

genchou

Member

Registered: 2016-09-23

Posts: 2

Devil Daggers on Arch

Hi,

I'm trying to get Devil Daggers to run on arch but I'm not meeting a lot of success. I first tried through wine (with which I installed Steam) but it doesn't start at all and the console doesn't output anything about it.

I then tried to install the linux version of Steam, and followed the instructions here https://wiki.archlinux.org/index.php/St … ve_runtime to get Steam to run. Devil Daggers installed fine but I get the following error when I try to run it:

/home/genchou/.local/share/Steam/steamapps/common/devildaggers/devildaggers: /usr/lib/libcurl.so.4: version `CURL_OPENSSL_3' not found (required by /home/genchou/.local/share/Steam/steamapps/common/devildaggers/devildaggers)

Any ideas how to circumvent this ? Has anyone succeeded to launch the game on Arch ?

Last edited by genchou (2016-09-23 13:23:22)

alphaniner

Member

From: Ancapistan

Registered: 2010-07-12

Posts: 2,810

Re: Devil Daggers on Arch

Shall I google

     /usr/lib/libcurl.so.4: version `CURL_OPENSSL_3' not found

for you?

---

But whether the Constitution really be one thing, or another, this much is certain - that it has either authorized such a government as we have had, or has been powerless to prevent it. In either case, it is unfit to exist.
-Lysander Spooner

genchou

Member

Registered: 2016-09-23

Posts: 2

Re: Devil Daggers on Arch

I'm asking because I did not find a working solution by googling. But thanks.

Last edited by genchou (2016-09-23 13:50:23)

Halcyon522

Member

Registered: 2015-04-09

Posts: 13

Re: Devil Daggers on Arch

Bump. I too have googled this issue, and attempted several workarounds, including trying to preload libs from libcurl-compat and libcurl-gnutls and such, and have had no luck. I'm running native runtime, BTW.

Also, commenting to snarkily say "Google it" is unhelpful and a waste of time.

WorMzy

Forum Moderator

From: Scotland

Registered: 2010-06-16

Posts: 11,868

Website

Re: Devil Daggers on Arch

It really isn't; this is the first time libcurl-compat has been mentioned in this thread. If OP had already tried to use that, then that would be helpful information.

Please post the exact command you are using to preload the compat library, as well as the full output you get from the application.

---

Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD

Making lemonade from lemons since 2015.

Trilby

Inspector Parrot

Registered: 2011-11-29

Posts: 29,534

Website

Re: Devil Daggers on Arch

Also post whether you are using libcurl-compat or lib32-libcurl-compat, you're using the latter one, right?

---

"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" -  Richard Stallman