You are not logged in.
Pages: 1
EDIT: It appears 1 of the pins on a connector on the card was bent shorting with an adjacent pin. After pulling it out and examining the card I noticed the pin and bent it straight. I plugged the card back in and it magically appeared on boot and in the lspci list. Lesson learned, inspect your hardware carefully if you're having problems.
I have a new LSI 9207-8i controller I am wanting to use to create a zfs array on my system. I'm not sure if this is a hardware, driver, or arch issue so I'm wondering if anyone has any guidance.
(It's a SAS HBA card, NOT a raid controller)
I currently have 2 pci-e slots open on my system which is a MSI X99 board with an i7-5960x in it. I have 2 video cards installed but I know there are still plenty of lanes left to allocate.
if I check lspci I'm not seeing the controller anywhere but I am seeing all of the other hardware.
Does anyone have any experience with these?
Last edited by planetes (2017-02-27 07:33:24)
Offline
Pages: 1