You are not logged in.

#1 2017-03-22 00:03:31

guanzd
Member
Registered: 2017-03-20
Posts: 7

Problem on adjusting resolution

Hi,
I am running Arch linux without X on my MacBook Pro (mid 2014, retina), and I also have a monitor (Acer K242 HL) which is connected with laptop through HDMI.
The under two picture show the difference on the resolution between two monitors.
I used the kernel compilation configuration menu to show it.
The first one is the screen of Macbook, it gives the full menu to me.
FluxBB
The second picture shows what acer give to me:
FluxBB

So I want set the resolution at 1920X1080 which is the resolution of acer. So I used uvesafb to make it.
I followed the official guide:https://wiki.archlinux.org/index.php/Uvesafb.
However, when I get the optimizing resolution, I found the following command cannot be done properly, because the folder uvesafb.0 doesn't exist

cat /sys/bus/platform/drivers/uvesafb/uvesafb.0/vbe_modes

I continued to do the procedure but I get nothing after rebooting.

So I want to know how to adjust resolution between two monitors.
BTW, I don't want to install X, because of some reasons.
Thank you !

UPDATE: I checked the mod named at v86d with command lsmod. But I did not get anything. It seems like the mod was not loaded for some reasons, what should I do to solve it?
Is it relevant to EFI?


Hwinfo didn't give me anything on supported resolution, is it relevant?

Last edited by guanzd (2017-03-22 12:44:32)

Offline

#2 2017-03-22 09:36:58

R00KIE
Forum Fellow
From: Between a computer and a chair
Registered: 2008-09-14
Posts: 4,734

Re: Problem on adjusting resolution

Maybe load the uvesafb module?


R00KIE
Tm90aGluZyB0byBzZWUgaGVyZSwgbW92ZSBhbG9uZy4K

Offline

Board footer

Powered by FluxBB