You are not logged in.
Pages: 1
Hello,
I'm sorry if this is not the proper place to post this problem, since I don't know if this should be posted in the media sub-forum or here
I've been trying to use amdgpu driver since apparently, if I'm not wrong, my laptop APU have a Kaveri GPU which is a GCN 2/Sea Island card Screenfetch Results. And since using the ATI open-source driver (radeon) yields unfulfilling results while playing 3D games, I decided to try using the AMDGPU. In short, I followed the instruction in the AMDGPU wiki. But, instead of using a custom kernel, I used the provided linux-lts kernel from arch repo, since I checked and it have been configured to have SI and CIK support enabled. So I have installed the linux-lts kernel, and checked that it does have support for SI and CIK SI and CIK support enabled, and also installed the newes linux-fimware.
Then I continue on to blacklist the ati driver and configure the amdgpu driver for the X-server, but, after reboot, there's a problem while loading the driver I think and causing it to hang/freeze, I panicked and then boot into CLI login, but it still produces the error and causes my laptop to hang/freeze. I can't find the boot log when it failed to load the X server and the driver so I took a picture of it Error picture, before that error, I didn't boot into CLI and there's a meassage saying that:
AMDGPU driver is loaded in 000.0001:0000 in minor 1
Or something like that. So I enter my installation from a live usb and configured my laptop to use ATI open-source driver again for the time being
Is this happening because there's some config that I needed to use in the kernel? If I compile and configure a custom kernel, would this problem will be solved? Or is my laptop APU just can't use the AMDGPU?
Thank you for the answers and attentions.
Last edited by plebeian (2017-04-02 01:31:31)
Offline
In short, I followed the instruction in the AMDGPU wiki. But, instead of using a custom kernel, I used the provided linux-lts kernel from arch repo, since I checked and it have been configured to have SI and CIK support enabled.
And the screenshot actually says "4.8.13"
Sea Island support in AMDGPU is considered "experimental" and there's a known Oops on your HW in even 4.9.x
https://bugs.freedesktop.org/show_bug.cgi?id=99387
Offline
And the screenshot actually says "4.8.13"
Sea Island support in AMDGPU is considered "experimental" and there's a known Oops on your HW in even 4.9.x
https://bugs.freedesktop.org/show_bug.cgi?id=99387
I checked the screenshot and run uname -r again, both did showed 4.9.20-1-lts. I am aware of it being an experimental but I rarely see any bug from googling about Kaveri and AMDGPU, but most setup is from a deskop GPU, not a Hybrid APU GPU, could be because of that. Also the link you provided seems included a patch for this choke on driver load, I'm going to try using it next weekend and see if it will solve the problem, if I can figure how to use it
Thanks for your response
Last edited by plebeian (2017-04-02 13:14:40)
Offline
Sorry, I was looking at this shot http://imgur.com/5l3CBYn and didn't read the kernel version on the other one ;-)
Patch is in mainline kernel but apparently not 4.10 (so you'll have to apply and build, yes)
Offline
Pages: 1