You are not logged in.
Pages: 1
Hello!
I have little but annoying problem with my PA setup. It has little distortions, cracks, glitches in played sound. I figured out, what is the problem, but I don't know how to fix it.
My unused audio outputs constantly (randomly couple times per second) change state from normal to "disconnected, unavailable".
Any suggestions how to fix it?
pavucontrol screenshots below.
http://imgur.com/a/n9l30
Offline
Remove/comment
load-module module-switch-on-port-available
in your /etc/pulse/default.pa
Offline
Bad news:
### Should be after module-*-restore but before module-*-detect
#load-module module-switch-on-port-available
It was commented.
Offline
hmm, can you post
amixer -c0
pacmd list-cards
pacmd list-sinks
Offline
double check with `pactl list modules` that it's not still loaded.
Offline
^ this as well, if you use GNOME with GDM there's a chance it loads pulse with its own configuration file and you'd have to figure out where that is and adjust the config there.
Offline
Pages: 1