You are not logged in.
Hi guys,
So I have 3 screens, two connected to my GPU and one connected to my Motherboard (Intel iGPU).
On windows, all 3 screens work fine, on Nvidia & intel drivers. But how do I make all 3 screens to work on Arch Linux?
Last edited by OctaVive (2017-04-17 12:37:30)
Offline
What have you tried so far? Have you read Multihead?
Offline
Hi,
Thanks for sharing the page. I came a step further. The third intel display is detected, but still black screen.
Here's screenshots:
VGA1 Is the third monitor.
I'm completely stuck at this point.
Offline
The first screen shot is display component of gnome control center? For the second please post the actual text.
Have you tried any of the configuration methods on the wiki page I linked?
Offline
Hi, here's the text:
I tried the configuration methods above. VGA1 is detected but still black screen.
Offline
Please post the system's xorg.log ( see Xorg#General to find the log's location )
Offline
And "glxinfo -l" - your width is beyond 4096px ...
Offline
After some hours of messing, I have finally fixed the issue.
I fixed the issue as follows:
1. I first installed the xf86-video-intel driver for the iGPU. This was the first and one of the easiest steps.
2. Then I added the following lines to the /etc/X11/xorg.conf (https://pastebin.com/9nZp9zwa)
3. Then I created a small script that has the proper configuration for all 3 monitors. I created this script in /home/mitchel/scripts and called it screen3 (You can call it whatever you want). (https://pastebin.com/XtwE1Gyb)
# There is a bug in the intel graphics driver where the screens must be suspended in order for the screen connected to the motherboard to turn on and work. I added this in the script. Only thing that has to be done is that I have to press enter during boot so all screens turn on again ("xset dpms force suspend" is used for this!). Also, another issue was that I had to manually set up the resolution in xrandr as xorg doesn't do this automatically and the screens are incorrectly positioned. The reason for the "sleep" command is because the first 3 commands won't work if the "sleep" command isnt there.
4. The last and easiest step, is to add the script to the startup. Cinnamon already has a small tool where you can easily add scripts to the startup.
Offline