You are not logged in.
Hi, everybody, I'm new to Arch Linux. I've been trying to install Arch Linux on one of my old laptops for the last two days, but always get stuck at the install step when I type "pacstrap /mnt base", it always gives me:
error: failed retrieving file 'core.db' from EVERY MIRROR
error: failed retrieving file 'extra.db' from EVERY MIRROR
error: failed retrieving file 'community.db' from EVERY MIRROR
I thought it must be my network connection problem, so I checked:
iw dev wlp3s0 link
It gives me:
Connected to XX:XX:XX:XX:XX:XX#MAC of my router# (on wlp3s0)
SSID: NOT WIFI #my wifi id#
freq: 2462
RX: 8487569 bytes (73462 packets)
TX:32645 bytes (544 packets)
signal: -33dBm
tx bitrate: 54MBit/s
bss flags: CTS-protection short-preamble
dtim period: 1
beacon int: 100
It clearly indicates that my laptop is "connected" to my wifi, but my router says it isn't. I think the wireless network configuration must be somewhere wrong here.
Could anybody please guide me to solve this problem so that I can continue the installation? Thank you very much.
Last edited by alexanderswang (2017-04-25 14:36:23)
Offline
"ip route"? (dhcp?)
"ping 8.8.8.8"? (ie. dns/resolv.conf issue)
Offline
I think the wireless network configuration must be somewhere wrong here.
So tell us what you did to configure the wireless network. Ethernet is enabled (e.g. automatic) on the installation iso, but wireless is not. What steps did you take to (attempt to) connect to your wireless network?
"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" - Richard Stallman
Offline
"ip route"? (dhcp?)
"ping 8.8.8.8"? (ie. dns/resolv.conf issue)
ping 8.8.8.8
gives me
connect: Network is unreachable
alexanderswang wrote:I think the wireless network configuration must be somewhere wrong here.
So tell us what you did to configure the wireless network. Ethernet is enabled (e.g. automatic) on the installation iso, but wireless is not. What steps did you take to (attempt to) connect to your wireless network?
1.
ip link set wlp3s0 up
2.
wpa_supplicant -D nl80211,wext -i interface -c <(wpa_passphrase "NOT WIFI" ".........") -B
I just tried the third step:
dhcpcd wlp3s0
The thide step works!!! Now my installation is going on. Thank you very much.@seth @Trilby
Last edited by alexanderswang (2017-04-25 14:37:20)
Offline