You are not logged in.
Pages: 1
Because of the GFW, I have to use shadowsocks. Now I have successfully configured shadowsocks, and I wanted to use it in command line, so I installed privoxy.
I have set the /etc/privoxy/config:
forward-socks5 / 127.0.0.1:1080 .
listen-address 127.0.0.1:8118Then I started privoxy.service and use the environment variable:
$ export http_proxy="http://127.0.0.1:8118"
$ export https_proxy="https://127.0.0.1:8118"However, when I do this:
$ curl www.google.comI get a strange output, which doesn't seem that I have successfully configured it at all:
No server or forwarder data received
Your request for http://www.google.com/ could not be fulfilled, because the connection to www.google.com (127.0.0.1) has been closed before Privoxy received any data for this request.
This is often a temporary failure, so you might just try again.
If you get this message very often, consider disabling connection-sharing (which should be off by default). If that doesn't help, you may have to additionally disable support for connection keep-alive by setting keep-alive-timeout to 0.I am 100% sure that my shadowsocks configuration is correct, because I used the same configuration on ubuntu, and it works fine.
So can anyone help me plz.
Last edited by Icarus_Radio (2017-05-01 02:25:22)
Offline
I just have some general advise, as I cannot help you with this specific problem:
You don't have to install privoxy in this case, there are other options.
Did you read this page https://wiki.archlinux.org/index.php/Proxy_settings
If you want stick with privoxy I would first try to make it work without shadowsocks.
Offline
I just have some general advise, as I cannot help you with this specific problem:
You don't have to install privoxy in this case, there are other options.
Did you read this page https://wiki.archlinux.org/index.php/Proxy_settings
If you want stick with privoxy I would first try to make it work without shadowsocks.
I have read this page and tried proxychains-ng, still no luck ![]()
Offline
Found the problem, port 1080 has already been used.
Thanks anyway ![]()
Offline
Pages: 1