You are not logged in.
Pages: 1
When I move a file to an external (USB 2.0) HDD and run the "sync" command, it takes a lot of time before it finishes and I can finally disconnect the volume.
If I try the command: watch -n 0.5 grep -e Dirty: -e Writeback: /proc/meminfo
I see "dirty" memory decreasing very slowly (about 200kb/sec)
lsusb -vvv gives:
Bus 001 Device 013: ID 18a5:0214 Verbatim, Ltd Portable Hard Drive
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x18a5 Verbatim, Ltd
Any idea what could be causing this?
Offline
Does it happen with all of your USB drives? Which filesystem are you using on that?
Offline
typically, data writes to the USB buffer very quickly (you'll get to 100% almost immediately), and then the speed to write to the USB device is determined by the USB version of the USB port and USB device you're using, so it can take a lot of time to write out to the device.
Last edited by HiImTye (2017-06-02 16:16:39)
Offline
if the filesystem is fat use "flush" mount option
Offline
Does it happen with all of your USB drives? Which filesystem are you using on that?
Ntfs. Just tried on a different (3.0 usb, ntfs) hdd, and it's a lot faster. So maybe the problem is the other drive.
Offline
Plasma desktop? Tried to disable baloo?
Offline
Plasma desktop? Tried to disable baloo?
It's Gnome 3.24 but it doesn't seem related to the DE.
Offline
Pages: 1