You are not logged in.
- Topics: Active | Unanswered
#26 2017-06-24 13:08:34
- seth
- Member
- From: Won't reply 2 private help req
- Registered: 2012-09-03
- Posts: 78,881
Re: bgn not showing iwconfig
with windows normally I had more range in connection I mean that I could go further without losing wifi signal than the phone and now its backwards
This really support the txpower issue except if it's not the sending but the receiving - just even if the chip had access and control over multiple antennas, I don't see a parameter in the module to control this...
Can you dump
netsh WLAN show allon windows?
Offline
#27 2017-06-27 07:20:24
- seth
- Member
- From: Won't reply 2 private help req
- Registered: 2012-09-03
- Posts: 78,881
Re: bgn not showing iwconfig
In addition it might still be possible to configure the antenannas (if there're multiple, this really depends on the actual HW) using "iw phy <phyname> set antenna ..." if their combination cannot deal with the EM noise, but that's a voodoo suggestion.
Offline