You are not logged in.
Pages: 1
As of roughly 1 week ago, I am no longer able to access the internet with a wired connection.
Output of
ip link:
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp0s31f6: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
link/ether 60:45:cb:6f:1c:ff brd ff:ff:ff:ff:ff:ff
3: wlp3s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
link/ether 3c:a0:67:69:65:b1 brd ff:ff:ff:ff:ff:ffWhat's strange to me is that when I
ping 8.8.8.8it just hangs, and
ctl+Creturns, for example,
14 packets transmitted, 0 received, 100% packet loss, and not
Network unreachable.
dhcpcd enp0s31f6only returns
sending commands to master dhcpcd processIf I remove my wired ethernet cord and
ping 8.8.8.8, it does return
Network Unreachble.
Does anyone have any hints as to what is going on here?
Offline
Please paste the output of:
uname -a && pacman -Q linux
systemctl list-unit-files --state enabledMoving to NC...
Offline
[kutz@mimolette ~]$ uname -a && pacman -Q linux
Linux mimolette 4.12.8-2-ARCH #1 SMP PREEMPT Fri Aug 18 14:08:02 UTC 2017 x86_64 GNU/Linux
linux 4.12.8-2
[kutz@mimolette ~]$ systemctl list-unit-files --state enabled
UNIT FILE STATE
autovt@.service enabled
dhcpcd.service enabled
getty@.service enabled
remote-fs.target enabled
4 unit files listed.Offline
What is the output of `systemctl status dhcpcd`?
Have you tried enableing the service for a specific instance? https://wiki.archlinux.org/index.php/Dhcpcd#Running
Offline
[kutz@mimolette ~]$ systemctl status dhcpcd
dhcpcd.service - dhcpcd on all interfaces
Loaded: loaded (/usr/lib/systemd/system/dhcpcd.service; enabled; vendor preset: disabled)
Active: active (running) since Tue 2017-08-29 20:49:56 EDT; 24h ago
Process: 260 ExecStart=/usr/bin/dhcpcd -q -b (code=exited, status=0/SUCCESS)
Main PID: 263 (dhcpcd)
Tasks: 1 (limit: 4915)
CGroup: /system.slice/dhcpcd.service
263 /usr/bin/dhcpcd -q -b
Aug 30 20:27:34 mimolette dhcpcd[263]: enp0s31f6: failed to renew DHCP, rebinding
Aug 30 20:43:35 mimolette dhcpcd[263]: control command: dhcpcd enp0s31f6
Aug 30 21:17:39 mimolette dhcpcd[263]: control command: /usr/bin/dhcpcd -q -w enp0s31f6[kutz@mimolette ~]$ sudo systemctl start dhcpcd@enp0s31f6.service
Job for dhcpcd@enp0s31f6.service failed because the service did not take the steps required by its unit configuration.Relevant `journalctl -xe`:
Aug 30 21:32:36 mimolette systemd[1]: Starting dhcpcd on enp0s31f6,,,
Aug 30 21:32:36 mimolette dhcpcd[1367]: sending commands to master dhcpcd process
Aug 30 21:32:36 mimolette dhcpcd[263]: control command: /usr/bin/dhcpcd -q -w enp0s31f6
Aug 30 21:32:36 mimolette systemd[1]: dhcpcd@enp0s31f6.service: PID file /run/dhcpcd-enp0s31f6.pid not readable (yet?) after start: No such file or directory
Aug 30 21:32:36 mimolette systemd[1]: Failed to start dhcpcd on enp0s31f6.
Aug 30 21:32:36 mimolette systemd[1]: dhcpcd@enp0s31f6.service: Unit entered failed state.
Aug 30 21:32:36 mimolette systemd[1]: dhcpcd@enp0s31f6.service: Failed with result 'protocol'.Offline
If you have a router try restarting it and see if it helps. Sometimes my old router won't respond correctly to dhcp requests. If I pull the plug and plug it back in, everything works again.
Offline
Still no luck after restarting/ pulling the plug a few times.
Offline
Pages: 1