You are not logged in.
- Topics: Active | Unanswered
#1 2017-11-03 00:30:43
- ezequiel.ezb
- Member
- Registered: 2017-08-14
- Posts: 33
Having trouble to unload kernel modules.[SOLVED]
I bought a cheap gamepad to use when playing emulators and enabled the hid_dr module to use it. After a while I decided to use joydev instead, since I had the impression I was having some delays when pressing a button in the gamepad. However, I found out later that the problems is with the emulator and now I want to revert to hid_dr due to some problems with joydev not detecting my gamepad, but every time I unload the module, be it with rmmod or modprobe, when I reboot the computer the module is still loaded, what should I do?
Last edited by ezequiel.ezb (2017-11-03 10:35:38)
Offline
#2 2017-11-03 00:36:19
- jasonwryan
- Anarchist
- From: .nz
- Registered: 2009-05-09
- Posts: 30,426
- Website
Re: Having trouble to unload kernel modules.[SOLVED]
Offline
#3 2017-11-03 00:38:34
- 2ManyDogs
- Forum Fellow
- Registered: 2012-01-15
- Posts: 4,648
Re: Having trouble to unload kernel modules.[SOLVED]
How did you "enable" the hid_dr module, and then the joydev module? Have you read the kernel modules wiki page?
(edit) snaked again
Last edited by 2ManyDogs (2017-11-03 00:39:14)
Offline
#4 2017-11-03 10:35:16
- ezequiel.ezb
- Member
- Registered: 2017-08-14
- Posts: 33
Re: Having trouble to unload kernel modules.[SOLVED]
How did you "enable" the hid_dr module, and then the joydev module? Have you read the kernel modules wiki page?
(edit) snaked again
modprobe hid_dr to enable it. Then I used rmmod to unload it. Same with joydev. Anyways, I blacklisted joydev and now everything is working fine.
Offline