Systemd unit fail

thygesteffensen · 2018-01-04 08:12:41

Hi,

I have some problems with my fresh installed arch linux and therefore went on google.
What i learned is, that i should run systemctl --failed, to see unit problems. I then got this output:

% systemctl --failed
UNIT LOAD ACTIVE SUB DESCRIPTION
systemd-localed.service loaded failed failed Locale Service

LOAD = Reflects whether the unit definition was properly loaded.
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
SUB = The low-level unit activation state, values depend on unit type.

1 loaded units listed. Pass --all to see loaded but inactive units, too.
To show all installed unit files use 'systemctl list-unit-files'.

However, I can't find a solution to my unit fail... Therefore I hope some of you could light up my problem!

Sincerely,
A fellow, newbie, arch user

Last edited by thygesteffensen (2018-01-04 08:13:08)

seth · 2018-01-04 08:56:04

systemctl status systemd-localed

However, this is likely not gonna help you.
Ensure to fix your locale (how did you install archlinux) and elaborate on "some problems", because a C locale does not necessarily explain "some problems".

Trilby · 2018-01-04 13:49:13

Welcome to the fourms. Please edit your post and add [ code ] tags to commands/output (click on the BBCode link below your post to learn more).

Also please describe the problem and symptoms that you actually want help:
http://xyproblem.info/

(edit: this isn't a 'typical' x-y problem, as you should certainly figure out why the service is failing and fix that too, but that is not the primary problem and is likely just a side effect of the real issue.)

Last edited by Trilby (2018-01-04 13:50:27)

Arch Linux

#1 2018-01-04 08:12:41

Systemd unit fail

#2 2018-01-04 08:56:04

Re: Systemd unit fail

#3 2018-01-04 13:49:13

Re: Systemd unit fail

Board footer