You are not logged in.
- Topics: Active | Unanswered
Pages: 1
Topic closed
#1 2018-02-16 10:01:54
- spphins
- Member
- Registered: 2018-01-07
- Posts: 4
How can I enable my Logitech G102 LED.
My mouse LED only lighting at launch or shutdown.after launched the LED will poweroff.Is there a way to workaround this ？
Offline
#2 2018-02-18 18:37:04
- Batou
- Member
- Registered: 2017-01-03
- Posts: 262
Re: How can I enable my Logitech G102 LED.
Please vote for all the AUR packages you're using. You can mass-vote for all of them by doing: "pacman -Qqm | xargs aurvote -v" (make sure to run "aurvote --configure" first)
Offline
#3 2018-03-16 05:00:17
- spphins
- Member
- Registered: 2018-01-07
- Posts: 4
Re: How can I enable my Logitech G102 LED.
I installed but it show cant find any device,I think it not support my mouse.
Offline
#4 2018-12-11 16:06:00
- brijgogogo
- Member
- Registered: 2018-05-21
- Posts: 1
Re: How can I enable my Logitech G102 LED.
Works fine for my Logitech G102!
Offline
#5 2018-12-11 16:36:42
- ewaller
- Administrator
- From: Pasadena, CA
- Registered: 2009-07-13
- Posts: 20,644
Re: How can I enable my Logitech G102 LED.
Taking this opportunity to close this older thread.
Nothing is too wonderful to be true, if it be consistent with the laws of nature -- Michael Faraday
The shortest way to ruin a country is to give power to demagogues.— Dionysius of Halicarnassus
---
How to Ask Questions the Smart Way
Online
Pages: 1
Topic closed