You are not logged in.
Hi,
I'm trying to install arch on my Dell XPS 15 9560 with a BCM4352 wireless card.
I have arch running on my desktop and built the broadcom-wl package from the AUR to the install it onto my archiso when I boot from USB.
However, when I boot into the live USB and install broadcom-wl, disable the b43 and ssb modules, enable the wl module (as well as the lib80211 and lib80211_crypt_tkip just in case), my wireless card still isn't being detected when I run ip addr.
Any ideas on steps I missed or other solutions?
Thanks,
Cryptik
EDIT: So after trying for hours to fix this, of course I fix it right after I make this post. The problem was that I also had to disable the bcma module, which is not listed in the wiki. Hopefully this helps someone in the future.
Last edited by cryptik (2018-04-01 01:09:08)
Offline